Testimonials
Watts Linkage

Nick, After years of talking about it, I finally added the Watts Link to my Contemporary. I should have done it years ago when I started talking about it. All of the shimmy in the rear end is gone. With the big FE there is a lot of torque and the car would run rough if I jumped on it hard. Now I jump and there is no sway, shimmy or rough running. It just goes. Good job Mate. Wasn't too difficult to install after we figured out what was different. Thanks for another great product. Dan
Read More ->


Cobra source - #1

Mr Acton, Your personal touch to the authentic Cobra parts and AC parts is fantastic. I am sure that without you my car would have been held up for years.............. Sincerely Jeff Gagnon CSX2375R
Read More ->


Acton Custom Best Of The Best

I trailered my 1991 427FE Contemporary Cobra to NH to have Nick install a watts linkage of his own design. Nick and Bonni are amazing and very gracious people with a phenomenal knowledge of Cobra's. The install went great and while looking my car over Nick didn't miss a beat. Quite a few other issues were discovered and corrected by Nick while I was there. When we were finished, I tested out the car and it performed flawlessly. The wheel hop, shake and trounce that I had been experiencing were virtually eliminated during a few good hard launches and it felt like a different car. I'm quite particular with my cars and pleased to say that Nick possesses all the knowledge and experience that I look for when having my Cobra worked on. Thanks Nick and Bonni! Charlie Malo
Read More ->


Custom Throttle Stop

Custom Throttle Stop

Thanks Nick for the custom throttle stop. It turned out just like I wanted and works great! Cobra enthusiasts like me are lucky to have your passion and talent in support of our cars. Cliff, United States
Read More ->


Soft top parts

I am new to the Cobra world with my recent purchase of an Autokraft AC MK IV. I want to thank-you for your kind help and awesome service with such minor purchases. Although the purchases were minor $ wise they were major in my ability to have an operational soft top just in case! I will look to you first for any of my future needs/enhancements. Thank-you again Nick,
Read More ->


Cockpit & Interior

Property categories:
Acton Custom fabricates many of the period-correct interior parts for your CSX Cobra or Replica. Our fit and finish are per original with no deviation. We can modify these parts to fit your car if you don't see your make listed under the 'fit' section.



Item Name Product Image Price

"Panic Handle" / Grab Handle

Made in the U.S.A. to original specs including rounded ends and countersunk holes for the attaching screws. Chrome grab handle, also known as the "Oh Shit" handle. Originally used on 289 Cobra. Priced as each.
"Panic Handle" / Grab Handle $112.00

Add:

289 High Beam Bezel

289 High beam warning light bezel and lens. NOTE: Socket, Bulb and Wire set available and sold separately. Sold as Each
289 High Beam Bezel $28.00

Add:

289 High Beam Socket, Bulb and Wire

289 High Beam Socket, Bulb and Wire. These are new to original spec. Sold as Each
289 High Beam Socket, Bulb and Wire $90.00

Add:

AC Brake Clutch Pedal Set

Perfectly cast aluminum AC pedal pads with correct font AC logo. Non-slip rubber grommets included. Originally use on 289 Cobra and 427 Cobra. 4 3/8 inches tall by 1 15/16 wide at center. These now come machined with a 5/16" diameter clevis pin hole and a 5/16" wide slot for the pedal arm. 2 Pedal Pads and 4 grommets included.
AC Brake Clutch Pedal Set $76.00

Add: